8
Assembly Instructions cont.
Step 9 Fitting the Poles to
the Portico Roof of Ensuite
tent
Lay out the inner Ensuite tent facing the
desired direction considering the future zipping
alignment with the Main tent. Ensure that you
have the door facing the direction you desire.
Select the two “grey fibreglass roof poles, blue
sticker”. Insert the poles diagonally from corner
to corner of the tent roof. Insert the pole ends
into the corner portico hubs attached to the
inner tent. Secure the inner tent to poles where
they cross.
Figure 9
Figure 8
HELPFUL HINT
Again, before attempting this step it helps to
open the doors of the tent. This allows for the
air to enter into the tent as you raise it.
Step 10 Installing the Wall
Poles of Ensuite tent
With the help of at least one other person,
select one of the four “black steel corner poles
with blue sticker”. Insert the end with a D ring
45cm from the top into the corner portico hub
and place the opposite end onto the ring and
pin assembly at the base of the tent floor. The
tent will stand up during this process. Attach
the pole clips located on the inner tent. Repeat
this process for the remaining three “black
steel corner poles with blue sticker”. With the
remaining “black steel pole with end caps” enter
the Ensuite tent and attached to the plastic “C”
clip on the inside wall to form a towel holder.
Step 8 Installing the side
Halo poles
After the fly sheet is securely in place, select
one of the two “grey fibreglass halo fly poles”
and place across the shortest side of the edge
of the fly sheet’s roof, see Figure 8. There is a
pole sleeve to slide the pole through on the
underside of the Fly Sheet and a reinforced
position on the inner tent to insert the pole
tips. Repeat this step for the remaining “grey
fibreglass halo fly poles” on the opposite side of
the tent.
Now secure the base of the fly to your tent by
attaching the black plastic hooks on the fly to
the corresponding pin and ring assemblies on
the base of the tent, see Figure 9.
