Polishing
Wait until the wax has dried fully
before continuing with polishing.
1. Remove the foam application
pad and replace with the clean
polishing bonnet.
WARNING!
ALWAYS START & STOP POLISHER
AGAINST THE SURFACE TO BE POLISHED.
2. Insert the battery, hold the
polisher on the surface and start
the tool.
Note:
Use only speeds 5, 8, & 10
for polishing applications to prevent
damage to the surface.
3. Allow the motor to reach steady
speed and move the polisher
using long sweeping strokes in a
crisscross pattern.
Note:
Do not apply excessive force to the polisher. Allow the polisher to
do the work.
4. Buff and polish the entire section until all dried polish is removed for a
swirl-free polished surface.
Polishing Tips
1. If streaking occurs while polishing, there is too much polishing wax on
the surface. Stop the tool, remove the bonnet and clean it of excess wax
before resuming polishing again.
2. It is best to start with large flat surfaces and ending with the hard-to
reach areas.
3. Apply polishing compound and polish in sections to ensure even
polishing.
4. Never force the polisher. The weight of the tool supplies adequate
pressure, to do the work. Applying additional pressure will slow the
motor, rapidly wear the bonnet,and greatly reduce the polisher speed.
This will slow the polishing rate and produce an inferior quality surface.
WARNING!
EXCESSIVE PRESSURE WILL OVERLOAD
THE MOTOR, CAUSING OVERHEATING AND
POSSIBLE DAMAGE TO THE MOTOR AND/OR
DAMAGE TO THE SURFACE.
5. Use a clean terry cloth bonnet (not supplied) for final buffing and polishing
to achieve a superior finish.
Before Polishing
Test a small inconspicuous area of the surface. Refer to polish
manufacturer’s instructions regarding application and drying times.
Using too much polish may:
• Reduce the life of the foam pad
• Make polishing difficult and take longer
• Cause the foam pad to come off
WARNING!
DO NOT USE ABRASIVE & CUTTING
COMPOUNDS TO POLISH WITH THIS TOOL. DOING
SO WILL VOID THE WARRANTY.
Applying Polishing Compound
1. Ensure the foam application pad is clean and fitted to the tool.
Note:
Never use the polishing
bonnet to apply polish to a surface.
2. Apply a small amount of
polishing compound or liquid to
the foam pad.
WARNING!
ALWAYS START & STOP POLISHER
AGAINST THE SURFACE TO BE POLISHED.
3. Hold the polisher on the
surface and start the tool.
Allow the motor to reach
steady speed and move
the polisher using long
sweeping strokes in a
crisscross pattern.
Note:
Start at the lower speed settings and slowly increase the speed as
required within the recommended settings. Use only speeds 5, 8, & 10 for
polishing applications to prevent damage to the surface.
Note:
Do not apply excessive force to the polisher. Allow the polisher to
do the work.
WARNING!
ALWAYS KEEP TOOL MOVING TO AVOID
DAMAGING THE WORK SURFACE.
4. Once polishing compound has been applied to the entire surface using
the foam pad, switch off the tool before removing the polisher from the
surface and removing the battery. You can now move onto the polishing
process.
0
I
05
BRUSHLESS
BRUSHLESS
BRUSHLESS
WARNING!
ENSURE HANDS ARE KEPT CLEAR OF
MOVING PARTS DURING OPERATION TO AVOID
INJURY.
PXBSPS-180
5. USING THE BUFFER POLISHER