5. When assembling the outer flange, ensure you select the correct
orientation to suit the type of disc being fitted.
Grinding disc: Place outer
flange with the raised lip
upwards.
Cutting disc: Place outer
flange with the raised lip
downwards.
WARNING!
WHEN USING THE ANGLE GRINDER
WITH A CUTTING DISC, A CUTTING GUARD (NOT
SUPPLIED) MUST BE FITTED PRIOR TO OPERATION.
FAILURE TO DO SO MAY RESULT IN SERIOUS
INJURY.
6. Screw the flange back onto the
spindle and tighten using the
pin wrench while holding the
spindle lock down.
2. FITTING THE DISC
1. Pull the pin wrench out from the side
handle.
2 . Depress and hold the spindle lock
to prevent the spindle rotating.
3. Align the pins of the pin wrench
to the flange holes and loosen by
rotating it anti-clockwise.
4. Remove the flange and replace
the grinding disc on the spindle.
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
WARNING!
ALWAYS WEAR GLOVES WHEN
CHANGING THE DISC OR GUARD. THE DISC, GUARD
AND WORKPIECE WILL BECOME HOT DURING USE.
