Installing The Battery Pack
1. Slide the battery into the tool
base until it clicks into place.
Removing The Battery Pack
1. Hold down the battery release
button and then slide the battery
out.
A safety guard should be used at all times whilst
operating the angle grinder, but there are times when
you should swap the guard, such as when switching
from a grinding disc to a cutting disc.
1. To remove a guard, you must
first remove the disc if one is
installed.
2. Loosen the safety guard locking
lever to allow it to spin.
3. Remove the guard by aligning the
notches and pulling away from
the tool.
4. Choose the correct guard for the job.
Semi open guards are designed for
grinding whilst the fully enclosed
guards are designed for cutting disks.
Use ONLY the semi-open
grinding guard with a grind
disc
Use ONLY the fully enclosed
cutting guard with a cutting
disc
5. Fit the correct guard to match the
correct disc, rotate to the desired
position and secure in place with
the locking lever.
3. CHANGING THE GUARD
4. FITTING THE BATTERY
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
