2. FUEL & OIL
3. CONNECTIONS
UNLEADED
FUEL
NOTE:
ALIGN THREADED CONNECTIONS CAREFULLY
TO PREVENT DAMAGING THREADS DURING
ASSEMBLY. TIGHTEN CONNECTIONS SECURELY TO
PREVENT LEAKS DURING OPERATION.
1. Remove fuel cap
2. Fill the tank with
unleaded fuel.
3. Replace the fuel cap
and clean any spillage.
4. Remove oil tank cap.
Note:
A Low Oil Cutout will shut
off the engine if the oil level
becomes lower than required.
This protects your water blaster
engine from operating without
proper lubrication.
5. Fill the engine with oil.
Note:
Use only 10W-30 oil
in the water blaster.
1. Connect the lance to the gun using a 22mm spanner or shifter.
2. Connect the high
pressure hose to the
gun using a 17mm
spanner or shifter.
WARNING!:
PETROL IS VERY FLAMMABLE. AVOID
SMOKING OR CAUSING ANY SPARKS OR FLAMES
NEAR FUEL. SELECT AN OPEN OUTDOOR AREA FOR
FUELLING AND MOVE AT LEAST 3M AWAY FROM THE
FUELLING POINT BEFORE STARTING THE MOTOR.
Fuel
Oil
The water blaster engine is shipped without oil in the engine. Oil must
be added before starting to prevent damage to the motor.
6. Fasten the oil tank cap
and clean any spillage.
OIL
OIL
Hose & Gun Assembly
High Pressure Hose
3. Connect the high pressure hose to the pump
. Tighten firmly using
hand force
Note:
Do not allow the high pressure hose to come in contact with the
hot muffler as this may damage the hose.
1