1
2. CHAIN BAR OIL
3. CHAIN BRAKE & CHOKE
OPERATION
Chain brake/Anti kickback guard
The chain brake operates automatically in the event of kick back.
Kick back occurs if the chain catches on the wood being cut. In the
event of the chain catching, the chainsaw will push back suddenly,
when this happens, your hand (which is on the side handle during
operation) will naturally move forward automatically causing the guard
to be pushed forward, engaging the chain brake and stopping the
chain.
CHOKE
- When the
chainsaw is cold
first pull out the
choke control to the
CHOKE position, (fully
withdrawn).
RUN -
Once the choke
control has been
pulled out, it returns
automatically when
the throttle trigger is
operated
IMPORTANT!:
DO NOT PUSH THE CHOKE IN
MANUALLY. THE CHOKE WILL AUTOMATICALLY
RETURN TO RUN POSITION WHEN THE THROTTLE
SAFETY LOCK AND TRIGGER ARE PRESSED.
Automatic oil feed system
The chainsaw is equipped with an automatic
oil feed system. This delivers oil to the bar and
chain.
Run the engine at medium speed and check
that the chain splatters a thin line of oil which
can be seen on the ground/material when the
bar is pointed downwards. This may take 15-30
seconds to occur.
Please refer to maintenance section overleaf
for detailed instructions on how to adjust the
automatic oil feed system if insufficient chain
bar oil is being applied to the chain.
WARNING!:
NEVER START WORK UNLESS THE CHAIN
AND BAR ARE LUBICATED
NOTE:
ONLY USE OIL THAT IS EXPRESSLY LABELLED
“CHAIN BAR OIL”
START
RUN
BRAKE ON
BRAKE OFF
1. Remove
BLACK
chain
bar oil cap and fill the
tank to about 80% of
its capacity with chain
bar oil.
Chain Bar Oil Tank
Capacity: 210ml
2. Fasten the chain bar oil
cap and clean any oil
spillage.
