1 Engraving Tip
2 Tip Release Screw
3 Stroke Adjustment Dial
4 On/off Switch
ELECTRIC ENGRAVER
KNOW YOUR PRODUCT
6
5 Stencil x 2
6 Hex Key
Scan this QR Code with your
mobile device to take you to the
online manual.
ONLINE MANUAL
1. FITTING ENGRAVING TIP
1. Loosen the tip release screw
using the supplied hex key.
3. Secure engraving tip by
tightening the tip release
screw.
2. Fully insert engraving tip. It should petrude roughly by 8.5mm.
SETUP & PREPARATION
Caution:
Ensure the tool is disconnected from the power supply
before performing any of the following operations.
