Ozito CMS-1621S, Инструкция по эксплуатации

Страница: 7 / 8

ASSEMBLY OF STAND
MITRE SAW
& STAND
210mm (8¼”)
STAND ASSEMBLY
STAND
FASTENERS
The stand is constructed by assembling each half of the structure and
then joining them together.
CMS-1621S
7 Bolt Small - 32 pc
8 Nut Small - 32 pc
9 Rubber Foot - 4 pc 10 Bolt Large with Rubber
Stopper - 4 pc
11 Saw Mounting Bolts - 4 pc
1 Short Upper Support - 2 pc
2 Short Lower Support - 2 pc
3 Long Upper Support - 2 pc 4 Long Lower Support - 2 pc
5 Upper Leg - 4 pc
6 Lower Leg - 4 pc
10 8 7 9
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1
6
2 3
4 5
x2
x2
x2
x2
x2
x2
x2
x2
x2
x2
x2
x2
x4 x4
1 Remove the stand components
from the box and group matching
pieces together. Check that you
have all the contents listed to the
left.
Note: All upper members can be
identified by the 2 holes very close
together.
2 Lay two upper and lower legs on
the ground aligning 2 of the bolt
holes, parallel to each other.
The upper leg sits outside the
lower leg.
3 Place one long lower support
in between the legs and align
the bolt holes. The side support
should have its lip on the high side
(facing up) and should sit inside
the legs.
4 Once aligned, insert small bolts
into the 2 aligned holes at both
sides of the lower support. Insert
the bolt from the outside and
screw a small nut onto each bolt
to secure (only hand tight at this
initial stage).
5 Place one long upper support
inside at the top of the legs where
the holes align. Insert a bolt from
the outside into the 2 aligned
holes at either side of the upper
support and hand tighten a small
nut onto each.
6 At this stage your frame should
look like this.
11