WARNING!
ONLY USE THIS STAND WITH THE PROVIDED
MITRE SAW OZITO CMS-1621S. THE STAND MUST NOT
BE USED WITH OTHER PRODUCTS OR FOR OTHER
APPLICATIONS.
FOR BEST RESULTS, THE USE OF A DRILL DRIVER AND
SPANNER (NOT INCLUDED) TO TIGHTEN THE NUTS AND
BOLTS IS RECOMMENDED.
CMS-1621S
x2
x2
x2
12 Once all of the members are
joined together and all fasteners
are assembled, tighten all nuts
and bolts firmly.
Note:
We recommend that the stand
is mounted to a stable surface
for additional stability.
13 The Rubber Feet can now be
fitted and the large bolts with
rubber stops inserted into the
rubber feet.
These bolts can be adjusted to
level the stand.
14 Place the saw on the stand. The
supplied mounting bolts, washers
and nuts should be used to
secure the saw to the top of the
stand.
7 Align one short lower support
inside the legs at the same height
as the long lower support. Ensure
that the lip of the side support is
facing up.
Insert 2 small bolts in the aligned
holes from the outside and
attaching a small nut (only hand
tight at this initial stage).
8 On the same side as Step 7,
assemble one short upper support
to the top of the upper leg using 2
small bolts and nuts.
One half of the frame is now
complete.
9 Repeat the same process for the
other side, which should leave
you with 2 identical halves.
11 Align the holes of each opposing
member. Bolts and nuts can be
inserted & tightened with hand
force only.
10 These halves can now be aligned
together to complete the frame.
Note:
Nuts & bolts should only be
finger tight at this stage.
