ONLINE MANUAL
Scan this QR Code with
your mobile device to take
you to the online manual.
0
25
50
75
100
125
150
0
(1)00
(3)00
(5)00
(7)00
(9)00
2
4
6
8
10
Lb/in²
(PSI)
kPA
(BAR)
PRESSURE GAUGE
kg/cm²
0
25
50
75
100
125
150
0
(1)00
(3)00
(5)00
(7)00
(9)00
2
4
6
8
10
Lb/in²
(PSI)
kPA
(BAR)
PRESSURE GAUGE
kg/cm²
Pre-Setup Checks
• Examine the machine for signs of transit damage. If damaged, do
not use, return to place of purchase
• The compressor should be set up near to the user.
• Avoid long air lines and long supply lines (extensions).
• Make sure the intake air is dry and dust-free.
• Do not set up the compressor in damp or wet rooms. The
compressor is designed to be used in dry rooms. It is prohibited
to use the compressor in areas where work is conducted with
sprayed water.
• Before you use the machine, make sure that the mains voltage
complies with the specifications on the rating plate.
WARNING!
ALWAYS KEEP THE COMPRESSOR
UPRIGHT. TIPPING THE COMPRESSOR ON ITS SIDE
MAY CAUSE THE OIL IN THE MOTOR TO LEAK OUT
AND DAMAGE THE UNIT.
Attaching The Support Foot
1. Place the supporting foot and
then a small washer onto the
M6 bolt. Thread this through
the hole in the foot bracket.
2. Thread the other small washer
and then the spring washer
onto the bolt. Secure the
assembly with the M6 nut.
Attaching The Wheels
1. Place the M10 bolt through
the wheel and a large washer.
Then slide this through the
hole in the wheel bracket and
a large spring washer. Secure
this with a M10 nut.
2. Press the wheel cap into
place.
3. Repeat steps 1 & 2 to fit the second wheel on the opposite side of
the tank.
1. Motor Housing
2.
On/Off Button
3. Tank Pressure Gauge
4. Pressure Regulator
5. Transport Handle
6. Regulated Pressure Outlet
7. Regulated Pressure Gauge
8. Pressure Tank
9. Support Foot
10. Drain Valve
11. Wheels
12. Safety Relief Valve
13. Intake Air Filter
14. Oil Sealing Plug
15. Oil Drainage Screw
16. Oil Level Window
17. Oil Filler Opening
AIR COMPRESSOR
KNOW YOUR PRODUCT
1. ASSEMBLY
SETUP & PREPARATION
WARNING!
ENSURE THE TOOL IS TURNED OFF
AND DISCONNECTED FROM THE POWER SUPPLY
BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS.
1
4
13
14
17
16
2
12
6
3
15
8
10
9
5
7
11
