AUX relay – switched terminal for TV set
17
The Vision III control unit provides a switched terminal that can be used to switch
the TV set‘s power supply on and off.
This switched terminal is always closed when the Vision system is in operation and
opens when the system is switched off (standby or sleep).
The TV set is then always disconnected from the on-board electric system when the
Vision system is not in operation, thereby saving standby power.
Caution:
The switched terminal does not represent a power supply! The TV set must be
supplied with power via a separated cable. Never branch the power for the
TV set off the Vision system‘s power supply! (Be sure to observe the
installation
instructions!)
Some TV sets are fi tted with an integrated satellite receiver. If such a receiver
supplies LNB voltage to control the antenna (see receiver control mode 2 or
mode 3), this device should not be connected to the switched terminal.
Wiring example:
Battery
TV set
Vision III
Control
unit
