The manual search is usually used to fi ne-tune the antenna to a found satellite in
case of adverse reception conditions.
If you wish to receive signals from a new satellite that is not yet stored as a search
satellite in the control unit, the manual search function can be used to tune the
system to this satellite.
Firstly, switch your receiver to a preset station that is transmitted by the satellite
selected.
At the control device, press repeatedly until the message
„Manual search“ appears in the display.
Programming sequence
for function
Manual search:
Level 1
Sub-level
A
Sub-level
B
Manual search
Press to access sub-level
A
and select an option.
Note:
Press the sat button to go
back one level.
Press or to select an
option.
Press or to edit the
option.
SAT mode
Entering the position
Manual satellite search
SAT mode
This display indicates that the system is in signal reception mode.
Press to display the currently received satellite.
„Entering the position“ is a selectable option of the main menu. Press to access
a list of countries, and use the buttons to scroll the list and use to se-
lect your location. This speeds up the satellite search.
The antenna is then optimally adjusted for the satellite search from your current
position (LNB and inclination angle).
12
