oxycom CABIN 400, Руководство по эксплуатации

Страница: 15 / 30

Application and use
17
00010605 B 15
of the reservoir. If the reservoir is only refilled and not fully drained, sediment will
build up much faster in the system.
Warning signal: after a set number of operating hours, the system
indicates when the water reservoir needs draining (LED 2 and LED 4
will flash). The system will however continue to function.
Proceed as follows to fully drain and replace the water in the water reservoir:
Step 1: Draining the water reservoir and checking the filter
1. Turn off the cooling function by pressing the button.
2. Remove the cap (including hose and cable) from the water reservoir.
3. Check that the water pump filter is clean.
If the filter looks dirty, remove and clean it. See "Cleaning the water pump filter"
on page 21 .
Note
After cleaning, do not forget to refit the filter. The system will
otherwise become clogged, which may cause damage to the OXYCELL.
4. Draining water off via the drain cock (open the drain cock, the position of the drain
cock depends on the type of vehicle).
5. Pour a little drinking water into the reservoir in order to wash away any sediment
(loosen the strap and shake the reservoir to and fro).
6. Close the drain cock.
Step 2: Filling the water reservoir
1. Replenish the reservoir with drinking water by pressing “reset” or by pouring water
into the reservoir.
(see "Required water purity and the use of additives" on page
13) .
2.
Add additive 1 to the water as indicated on the packet.
Note
Additive 1 improves the distribution of the water in the elements of the
OXYCELL heat exchanger.
3. If the water pump filter has been cleaned: ensure that the filter has been
correctly refitted to the pump .
4. Refit the cap (including hose and cable).
5. Turn off the "insufficient water in the water reservoir" signal (if
active)
6. (see illustration on the right: LED1 flashes) or the "drain and
refill the water reservoir" signal (see the illustration below: LED4
flashes), by pressing the
button.
The CABIN 400 is now ready for use again.