oxycom CABIN 400, Руководство по эксплуатации

Страница: 11 / 30

Application and use
17
00010605 B 11
activated. (If the CABIN 400 has been switched off for a long period, the cooling
initialisation program will start up first.)
Note
As soon as the CABIN 400 is switched on, the function that was in use
when the unit was switched off will be reactivated.
3.3 Adjusting ventilation settings
Press the fan switch . Each time the switch is pressed, the next ventilation setting
is activated:
Figure 3.4
Ventilation settings 1 to 4 are activated sequentially.
3.4 Adjusting cooling settings
The CABIN 400 must be switched on and the desired ventilation setting must be
activated.
1. Press the cooling switch .
Cooling starts. The fan will temporarily revert to level 1 so
that the OXYCELL can be properly moistened. The LEDs L1, L2,
L3, L4 on the operator panel will start to flash, when the
cooling function is first switched on. Water is pumped up from
the water reservoir to the sprinkler in the roof unit in order to
moisten the OXYCELL (heat exchanger). The moistening
process when cooling first starts lasts about 3 minutes. The
fan operates at level 1 during this period.
2. The cooler will revert to the ventilation setting that had been selected before the
cooling function was activated. It is now possible to select any one of the
ventilation settings as required, by pressing the fan switch
.
Figure 3.5 Cooling settings 1 to 4 are activated sequentially.