1：
1. VERSION 1.0 is the software version number of the camera, and it will change as the product’s upgrade.
2. PROTOCOL P/D is control agreement, can support P, D protocol, and it will change as the dial switch chooses
different protocol.
3. ADDRESS 1 for Protocol P is control address, can support 256 addresses, and it will change as the dial switch
chooses different protocol.
4：
ADDRESS 0 for Protocol D is control address, can support 256 addresses, and it will change as the dial switch
chooses different protocol.
5：
COMM 2400.N.8.1 is communication information, 2400 is communication baud rate, there are 1200, 2400,
4800, 9600 four baud rate for different dial switch. N.8.1 means no verify, 8 data byte, 1 dwell position.
After the dome finish configure, you can operate the camera as the following way:
5.2 Basic Function Operation
OPERATION PROCEDURE
Pan/Tilt
1. To rocker control keyboard, camera will rotate to the operation
direction if the rocker leans to one direction of up/down/left/right.
The speed depends on the distance between rocker and center. The
camera will move slowly to the operation direction if move the
rocker lightly in one direction. The camera will speed to MAX. Speed
of continuously move the rocker in one direction. The camera will
stop when the rocker returns to the center.
2. To 2-dimension control keyboard, the camera will rotate to the
operating direction if press direction key. The speed depends on the
current speed code. To our KBD100 keyboard, press any one of 1-9,
and then press direction key. The pressed number key is the speed
stage. The larger number it is, the higher speed will be. The camera
stops action of release the key.
3. To computer software control, press the direction key of control,
the camera will rotate to the operating direction. The speed
depends on current speed code. Some software can implement
continuous rotation and some only can implement dot movement.
Please refer to the software instruction provided by the
manufacture for detailed operations.
This dome can do 3600 continuous pan rotation and +20~-920
vertical rotations. It will stop rotate when reaching tilt limit.
STOP SCAN
Preset 96(hit“9”+“6”+ “Preset”)
PRESET TOUR
Preset 98(hit“9”+“8”+ “Preset”)
AUTO SCAN
Preset 99(hit“9”+“9”+ “Preset”)
Pattern
1.
press pattern scan setting to start
2.
run the camera as the designed route
3.
press pattern scan setting to stop
4.
run the pattern scan, the camera will run the recorded route
ZOOM WIDE
1.Press the ZOOM WIDE button or turn the joystick clockwise until
you have the picture you want
2.release the button or joystick
