OWC MERCURY ELITE PRO DUAL
DEVICE SETUP
7
6. Using eight of the larger screws from the packet you
removed in Step 3, fasten the inner chassis to the hard
drives. There are four screw holes on each side of the
inner chassis, circled above in red.
7. To determine the correct orientation of the outer
enclosure relative to the inner chassis, turn the outer
enclosure on its side and look at the bottom. As
shown above, the screw holes at the front of the outer
enclosure are close to the silicone feet. The screw
holes at the rear of the outer enclosure are farther
away from the silicone feet.
8. Once you know the correct orientation from Step 8,
slide the inner chassis back into the outer enclosure
as shown.
9. Once the front grill of the inner chassis sits flush with the
edge of the outer enclosure, turn the device on its side
again. The screw holes in the outer enclosure should
line up with the screw holes in the inner chassis. Use
the four smaller screws to fasten the inner chassis to
the outer enclosure, shown above.
The assembly process is now complete.
REAR
FRONT
