OWC MERCURY ELITE PRO DUAL
INTRODUCTION
3
1.4 Front View
1. Power
— This LED emits a solid blue light when the
Elite Pro Dual is powered on.
2. LEDs 1 & 2
— These LEDs represent the two
drives inside the Elite Pro Dual. During normal
activity, each of these LEDs will blink green when
the corresponding drive is accessed. If one of the
drives in the Elite Pro Dual fails, or if the drive bay
is empty, the corresponding LED will turn solid red.
3. Rebuild
— If the Elite Pro Dual is set up as a RAID 1
and one of the hard drives is being rebuilt, this LED
will blink green during the rebuild process. The LED
that corresponds to the hard drive being rebuilt will
also blink green.
1.5 Rear View
1. ON/OFF Switch
— Turn power to the Elite Pro Dual
on and off with this switch.
2. DC IN
— Connect the included power supply here.
3. FireWire 800 ports
— Attach the included 9-9 pin
FireWire 800 cable to one of these ports and to your
computer. Use the other FireWire 800 port to daisy
chain other FireWire 800 devices.
4. USB 3.1 Gen 1 port
— Attach the included USB 3.1
Gen 1 (Standard-A to Standard-B) cable here.
5. RAID Dial
— Set the RAID mode here.
6. Kensington
®
Security Slot
— Connect a security
tether here.
1
2
3
1
2
3
4
5
6
