OWC Jupiter Mini-SAS
SySteM Setup
2.2.2 Unit Removal
1. before removing the Jupiter expander Rack
835 from your rack, it is recommended that
you remove all drives to make it easier to
remove Jupiter from the rack and to reduce
the risk of personal injury and/or equipment
damage. If necessary, make sure to note the
drive locations so they can be reinserted into
the same locations later.
2. Make sure all cables including data and power
are disconnected from the Jupiter unit.
3. Remove the four rack securing screws from
the front of the Jupiter unit as shown in
Figure
2.2.2a
.
4. Using the handles, pull the rack toward you
until it is stopped by the safety latches.
5. It is recommended to have a second person
assist the removal at this point. Press the
security latches while simultaneously sliding
the unit out just past the security latch as
illustrated in
Figure 2.2.2b
.
6. Make sure both people removing the unit
have a firm grip on the rack front and base
and are prepared to support the full width of
the unit. Continue slowly pulling the rack out
until it is free from the rails.
!
Review precautionary measures from beginning of Section 2.2 before proceeding.
Rack Securing Screws
Figure 2.2.2a
Keep unit level
while removing
Push security
latch to release
Slide out of rails
Figure 2.2.2b
10
