NEO S-Series Library Service Manual
Replacing Parts
10400666-005
©2015-20 Overland-Tandberg
30
Install New Magazine
1.
Load the
tape cartridges
into the new magazine in the same locations that they were
in the old magazine.
2.
Supporting the magazine underneath, position the
new magazine rails
onto the
alignment rails.
3.
Using the handle, push the
magazine
slowly into the library until the magazine release
latch snaps into place.
The magazine automatically locks into place when it is correctly installed.
Replace the Base Chassis
WARNING:
To reduce the risk of electric shock or damage to equipment, always remove any
power cords while working with the library.
WARNUNG:
Um das Risiko eines elektrischen Schlags oder Schäden am Gerät zu vermeiden,
ziehen Sie stets den Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT:
Pour réduire le risque de choc électrique ou endommagement de l'équipement, retirez
toujours les cordons électriques en travaillant avec l'appareil.
CAUTION:
While working with the library, observe standard Electrostatic Discharge (ESD)
precautions to prevent damage to micro-circuitry or static-sensitive devices.l
Prepare the Unit
CAUTION:
In the NEOs library, do not replace both the library controller and the chassis at the
same time as the serial numbers for both cannot be updated when both are replaced
simultaneously. If you receive a new library controller and chassis for the same unit, first install
the new library controller in the old chassis as directed in the
Spare Library Controller
Replacement Instructions
, then follow these provided instructions to replace the chassis.
The following items are included in the new chassis and should not be removed from the old
chassis:
•
Center bezel with the OCP
•
Magazine access doors
•
Robotic assembly
•
Spooling mechanism
