NEO S-Series Library Service Manual
Replacing Parts
10400666-005
©2015-20 Overland-Tandberg
28
b.
Slide the
power supply
into the library (1) until it is flush with the back panel of
the library.
c.
Finger-tighten the
blue captive thumbscrews
(2) to secure the power supply.
d.
Attach the supplied
AC power cord
to the new power supply and plug it into the
same AC circuit previously used.
6.
Press the Base Module
power button
for one to two seconds to power on the library.
Replace a Magazine
WARNING:
To reduce the risk of electric shock or damage to equipment, always remove any
power cords while working with the library.
WARNUNG:
Um das Risiko eines elektrischen Schlags oder Schäden am Gerät zu vermeiden,
ziehen Sie stets den Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT:
Pour réduire le risque de choc électrique ou endommagement de l'équipement, retirez
toujours les cordons électriques en travaillant avec l'appareil.
CAUTION:
While working with the library, observe standard Electrostatic Discharge (ESD)
precautions to prevent damage to micro-circuitry or static-sensitive devices.l
Unlock a Magazine with OCP or RMI
NOTE: As a best practice, perform this procedure while applications are idle. While the magazine is
extended, the library robotic assembly cannot move media.
Unlock the magazine using the OCP or RMI. Only one magazine or mailslot can be open at a
time.
NOTE: If these methods fail, or if a magazine needs to be removed when the power to the device is
off, you can release the magazine manually. See
Remove the Magazine Manually on page 29
.
1.
Open the
magazine access door
.
2.
Log in as an administrator in
OCP
or
RMI
.
3.
Unlock the magazine.
NOTE: If not removed, the magazine and mailslot will relock after 30 seconds.
