Overland Storage PowerLoaders AIT-2, Руководство пользователя и инструкция по установке

Страница: 34 / 106

2-10
u
Installation
S
ETTING
U
P THE
R
ACK
M
OUNT
M
ODEL
13) Slide the module in and out several times as shown in Figure 2–10 , ensuring that the inner and
outer slide locks engage, and that the module does not bind against the slides.
Figure 2–10. Sliding Module In Rack
14) If binding or misalignment with other rack devices occurs, loosen the four screws that secure
the slides to the front rails and the four screws that secure the slides to the rear rails and
realign the module. Retighten the screws.
15) If necessary, repeat steps 9 and 10 until the module does not bind against the slides.
16) Install two clip nuts on each front rail at the height of the front panel mounting screws
(thumbscrews).
17) Slide the module into the rack as shown in Figure 2–11 , and tighten the thumbscrews.