En-8
1-888-514-1663
|
WWW.OUTLANDLIVING.COM
SECTION 1:
ASSEMBLY (continued)
STEP 3
Mount End Panel
***loosely***, but do not tighten
.
STEP 4B
Mount (2x) Cross Bars.
STEP 4A
Locate the (4x) press-fit studs on the End Panels.
Mount the Propane Cylinder H-Frame Support onto the press-fit
studs of the End Panels.
Fit the holes in the ends of the H-Frame Support over the studs of
one End Panel. Then, fit the holes over the studs of the other End
Panel. You may need to lightly pull the second End Panel back a bit
to fit the holes over the studs.
IMPORTANT:
Note the labels with Arrows on the H-Frame Support.
The Arrows should point up to the sky during the installation.
STEP 4C
Once the (2x) Cross Bars are firmly installed, firmly tighten the (8x)
End Panel screws.
4
5
6
(4x) M6 SCREWS
(8x) M6
SCREWS
PROPANE CYLINDER
H-FRAME SUPPORT
(2x) CROSS BARS
(2x) THIS WAY UP
ARROWS
(4x) PRESS-FIT
STUDS
END PANEL
