Owner & Safety Manual
En-13
D.403.000.V4
OUTLAND LIVING
™
FIRE TABLE OWNER & SAFETY MANUAL
SECTION 2:
IGNITION (continued)
FIRE TABLE WON’T LIGHT? IGNITION PROBLEM?
IGNITION TROUBLESHOOTING
STEP 1
Wait 5 minutes for any gas to dissipate. Locate the igniter cable
under table. Ensure the igniter cable is firmly attached to the gas
valve. Follow the ignition sequence again. If still no results after three
tries move to step 2 below.
ENSURE IGNITER (UNDER IGNITER COVER)
IS FREE FROM DUST AND NOT BLOCKED BY
GLASS ROCKS
STEP 2
Turn the gas cylinder valve to the ‘Closed’ position. Wait 5 minutes
for any gas to dissipate. Ensure igniter cover is not covered by glass
rocks. This helps air circulate. Inspect the ignition electrode (under
igniter cover) to ensure it is free from dust and not blocked by glass
rocks or other debris. Use a dry clean cloth or tissue to very lightly
wipe clean igniter tip.
ENSURE IGNITER
CABLE IS FIRMLY
ATTACHED
CAUTION:
Watch for glass dust.
WARNING HAZARD:
USE A TOOL OR WEAR GLOVES TO MOVE
GLASS ROCKS. AVOID BLOWING GLASS DUST IN THE AIR.
After waiting for 5 minutes, visually inspect the spark by rotating
the knob to high without turning the gas back on at the cylinder.
Ensure the spark gap is 3-5mm (1/8”-3-16”) from the burner port
and has a clear path. Once you ensure the igniter is operating
properly repeat the ignition sequence in section 2.
