labels. The sensor detects 3 gaps and generates the exact gap space
between the labels.
The form feed can not handle labels longer than 6 Inch (Inch = 2,54 cm)
automatically as a result set label length manually.
•
Checkbox
ON
Activate this checkbox to activate LEARN MODE.
•
Label
Length
Enter label length (100 = 2,54 cm) if labels are longer than 16 cm (6 Inch).
Pause/Cut Mode [5]
•
Normal (continous printing)
The print process ends when the amount of printed labels is reached.
•
Tear/Cut after each label
The paper feed pauses after each printed label so it can be torn off. The
next print job starts after the tear off and the previously set pause after tear-
off.
•
Tear/Cut after each print job
The paper feed pauses after each print job and the printed labels can be
torn/cut off.
•
Pauses After Tear Off
The next print cycle starts after the pause after tear-off which was set.
Tear/Cut Position Adjustment [6]
In case the tear edges are not centric between the labels you can adjust
the position in both directions (forward/backward) doing so by pressing plus
or minus.
Set radiobutton plus or minus.
Enter a value in the data field (1 = 0,254 mm).
Print the next label and check if the tear position is centric.
Inklevel Popup [7]
After each print job the ink level popup appears. The software informs the
user about the current fill level of the ink cartridges.
20
