Page 4 of 27
8.
Griddle installation must conform with local codes,or in their absence,with either the National Fuel
Gas Code,ANSI Z223.1/NFPA 54,Natural Gas and Propane Installation Code,CSA B149.1,or
Propane Storage and Handling Code ,B149.2.
Griddle,when installed,must be electrically grounded in accordance with local codes,or,in
the absence of local codes,with the National Electrical Code,ANSI Z21.58-2018,or the Canadian
Electrical Code,CSA 1.6 - 2018.
This Griddle is intended for outdoor use only,and should not be used in a building,garage,or any
other enclosed are.
This Griddle is not intedned to be installed in or on recreational vehicles and/or boats.
Never use any other type of fuel for this griddle other than LP gas(propane).
Only use the pressure regulator with a type 1 connector that is supplied with this gas griddle.
Before each use,check the gas hose for excessive abrasion,cracking,fraying,wear,or cuts.
Replace a hose assembly showing those signs with the hose assembly specified in the parts list
before using the griddle.
Always perform a Leak Test before operating your griddle.
1. Do not stroe a spare LP-gas cylinder under or near this appliance.
2. Never fill the cylinder beyond 80 percent full; This may cause release of gas from the safety
release valve;
3. If the information in "(1)" and "(2)" is not followed excatly, a fire causeing death or serious
injury may occur.
