Otto Bock Start B2, Инструкция по эксплуатации

Страница: 34 / 44

Required materials
• 4 belt loops (e.g. from Unwin Safety Systems, Q’Straint)
8.17.2 Using the product in a vehicle
WARNING
Positioning in vehicles for transporting persons with reduced mobility
Serious injuries in case of accidents due to user error
► Positioning of the product in vehicles for transporting persons with reduced mobility may only be performed
by qualified personnel.
► The product must always face forwards when it is used as a seat in a vehicle for transporting persons with
reduced mobility.
► Instruct the qualified personnel regarding the mounting points on your product described below.
WARNING
Inadequate transportation safety
Loss of safe restraint due to failure to observe transportation instructions
► Observe the following instructions for correct transport safety in the vehicle for transporting persons with
reduced mobility.
► If necessary, instruct the qualified personnel on the following information.
Securing the product in the vehicle for transporting persons with reduced mobility
The wheelchair is secured in the vehicle for transporting persons with reduced mobility with the help of four belt
loops, on which the vehicle side wheelchair restraint belts are attached.
The fixation points of the belt loops are marked with stickers (pattern). These stickers show where the user has to
pass the belt loops around the frame tube:
•
The stickers that identify the front fixation points are found on the front frame near the caster attachment device
on each side (example: see fig. 63, item 1).
• The stickers that identify the rear fixation points are found on the rear vertical frame tube on each side
(example: see fig. 63, item 2).
63
Attaching the belt loops
1) Position the product in the vehicle for transporting persons with reduced mobility. For more information, please
refer to section 5 in the brochure “Transporting persons with reduced mobility”, order number 646D158.
2) Front fixation points: Attach one belt loop around each of the frame tubes on the left and right, wrapping
them around the frame tubes at the marked position once or twice depending on the length (example: see
fig. 65, item 1).
3) Engage the hook of the respective vehicle side wheelchair restraint belt in the belt loop (see fig. 65, item 2).
4)
Rear fixation points:
Attach one belt loop around each of the frame tubes on the left and right, wrapping them
around the frame tubes at the marked position (example: see fig. 66, item 1).
5) Engage the hook of the respective vehicle side wheelchair restraint belt in the belt loop (see fig. 66, item 2).
6) Tighten the vehicle side wheelchair restraint belts at the front and rear as firmly as possible.
→
The product showing the correct positioning of the attachment straps (see fig. 67).
34
Use
Start B2