Otto Bock Kimba, Инструкция по эксплуатации

Страница: 9 / 44

5.1.2 Mounting the padding
INFORMATION
►
If necessary:
Before attaching the back support pads, all required components have to be installed on the
frame tubes of the back support insert. First mount the canopy adapters (see page 28) and pads, only then
the back support pads.
► Adjust the seating unit prior to mounting the back support pads (see page 31 ff).
► If the product was ordered without padding, please note the information in the section “Delivery without
padding” (see page 29).
a) Attaching the back support pad
1) Open the zip on the pad.
2) Pull the top of the pad over the back support and close the zip (see fig. 8).
3) Pull the lower end of the pad through between the back support and seat bottom. Slide the eyelets onto the
rotary swivels and close the twist locks (see fig. 9).
4)
If necessary:
Push the back support pad under the supports at the sides (not illustrated).
b) Attaching the seat pad
1) Attach the pad with the hook-and-loop fastener (see fig. 10).
2) Push the seat pad under the supports at the sides (see fig. 11, item 1).
3) Attach the rubber bands on the left and right sides of the leg support (see fig. 11, item 2).
8 9
10 11
6 Installing options/accessories
INFORMATION
Please also observe the adjustment instructions in the section "Settings" (see page 30 ff.).
9 Kimba
Installing options/accessories