Otto Bock Juvo, Инструкция по эксплуатации

Страница: 110 / 124

Flashing LED Error/warning Cause Possible measure
Attendant control fault Defective attendant control Switch off attendant control and turn
control panel off/on
Joystick error Attendant control joystick
not in home position when
the unit is turned on Switch off attendant control and move
joystick to home position before
switching the unit on
Switch control panel off/on
Communication error
between the attendant con­
trol (joystick) and the con­
trol panel/controller
Defective cable, loose plug
connection Check cabling / plug connections
7.5 Behaviour in case of breakdowns
INFORMATION
Note that the following instructions also apply for flat tyres. Independent tyre repairs by the user or an attendant
are not intended.
In case of breakdowns, promptly inform the qualified personnel that adapted the product or the manufacturer's ser­
vice (see inside back cover or back page for addresses). All relevant details have to be provided, such as the type
of power wheelchair, type of breakdown (e.g. problems with the motor) and if possible, the serial number of the
power wheelchair.
To get help faster, noting the address and telephone number of the responsible specialist dealer in the field
provided on the back of these instructions for use is recommended. This information should be kept on hand,
especially when driving outdoors.
8 Disposal
8.1 Safety instructions
NOTICE
Disposal of batteries
Pollution due to incorrect disposal
► Observe the information printed on the batteries by the manufacturer.
►
Note that the batteries may not be disposed of as household waste.
8.2 Disposal information
Return the product to the specialist dealer for disposal.
Please return defective batteries to your specialist dealer when buying new ones.
All components of the product must be disposed of properly in accordance with the respective national environ­
mental regulations.
9 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
9.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
9.2 CE conformity
This product meets the requirements of the European Directive 93/42/EEC for medical devices. This product has
been classified as a class I device according to the classification criteria outlined in Annex IX of the directive. The
declaration of conformity was therefore created by the manufacturer with sole responsibility according to Annex VII
of the directive.
The product meets the requirements under the RoHS Directive 2011/65/EU of the European Parliament and of the
Council of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic
equipment.
110
Disposal
Juvo