103
Status
LED
Charging status
indicator (5 LEDs)
Error
Resolution
LED 2 and 4 are lit up Charger excess tem
perature
LED 1, 3 and 5 are lit
up
Excessively high or
low temperature of the
prosthesis
Check whether the
specified ambient con
ditions for charging the
battery are met (see
page 97).
The LED
ring is lit
up yellow
LED 3 is lit up
The prosthesis is not
being charged
Distance between bat
tery charger and
receiver of the char
ging unit too great.
Connection may be
improved by reducing
the distance between
the charger and receiv
er of the charging unit.
The LED
ring is lit
up green
The battery charger is
functional but not con
nected to the receiver,
or the distance
between the battery
charger and receiver
of the charging unit is
too great.
Connect the battery
charger or reduce the
distance between the
charger and the receiv
er of the charging unit
on the prosthesis.
The LED
ring is
flashing
red
The prosthesis is not
being charged
Defective battery
charger.
Reset the error by dis
connecting and con
necting the power sup
ply.
If the error persists, the
battery charger and
power supply must be
inspected by an
authorised Ottobock
Service Center.
16.2.3 Error messages while establishing a connection with the cockpit app
Error message
Cause
Correction
Component was con
nected to another
device. Establish con
nection?
The component was
connected to another
device
To disconnect the original connection, tap
the "
OK
" button.
If the original connection is not to be dis
connected, tap the "
Cancel
" button.
Mode change failed
An attempt was made to
switch to a different
MyMode while the com
ponent was in motion
(e. g. while walking)
For safety reasons, switching MyModes is
only permitted when components are at
rest, e. g. while standing or sitting.