Otto Bock 50K6-1, Инструкция по эксплуатации

Страница: 10 / 80

10
NOTICE
Contact with oils, salves, lotions or other products that contain oils or acids
Insufficient stabilization due to loss of material functionality
► Do not expose the product to oils, salves, lotions or other products that contain oils or acids.
NOTICE
Improper use and changes
Change in or loss of functionality as well as damage to the product
►
Use this product with care and only for its intended purpose.
► Do not make any improper changes to the product.
5 Handling
INFORMATION
►
The daily duration of use and period of application are generally determined by the physi­
cian.
►
The initial fitting and application of the product must be carried out by qualified personnel
according to the instructions of the treating physician.
► Consult a physician if any exceptional changes are noted (such as worsening of the com­
plaint).
5.1 Selecting the Size
1) Measure the circumference of the thigh 15 cm above the center of the patella.
2) Measure the circumference of the lower leg 15 cm below the center of the patella.
3) Determine the size of the brace (see size chart).
5.2 Adaptation
CAUTION
Incorrect or excessively tight application
Risk of local pressure and constriction of blood vessels and nerves due to improper or exces­
sively tight application
►
Ensure that the product is applied properly and fits correctly.
1)
Donning:
Hold the brace on both sides with the donning loops (1) and pull it over the knee
until the patella cutout is centered on the patella.
2) Positioning (see fig. 2) : Place the patient's knee in a 20°-30° flexion position. Grasp the
patella carefully and guide the patella support (2) to the outer edge of the patella.
3)
Clasping
(see fig. 3)
:
Hook the upper ratchet hook (3.1), with slight tension applied to the
spring elements (4), onto the ratchet strap (5.1). Hook the lower ratchet hook (3.2), with slight
tension applied to the spring elements (4), onto the ratchet strap (5.2).
INFORMATION: The maximum pre-tension is specified by a mark on the ratchet hook.
Apply the maximum amount of pre-tension by aligning the mark with the splint (10).
→
The patella support (2) lies against the outer edge of the patella.
4)
Fastening
(see fig. 4)
:
The patella support is held in the upper and lower guide channels (8)
by the hook and loop guides (9). The hook and loop guides can be readjusted if necessary.
5) Functional check (see fig. 5) : Carefully flex the knee to the degree approved by the attend­
ing physician and extend it to check that the brace is working optimally and is positioned
properly.
→
Does it require adjustment? See 6 "Readjustment"
→
Is the brace positioned properly?
See 7 "Shorten"