4.2 Options
•
External buttons (for connection to the 3.5 mm jack sockets on the connector strip) – e.g. piko button
•
Joystick attachments
4.3 Storage
Store the product in a dry, enclosed room with sufficient air circulation and protection from external influences.
Maintain an ambient temperature from
-15 °C to +40 °C [5 °F to 104 °F]
and relative humidity of
45% to 85%
.
5 Preparing the product for use
5.1 Installing and adjusting the tray
INFORMATION
►
If you have ordered a tray as an optional extra, you need to mount the tray before installing the tray module.
Take note of the user's requirements and the technical conditions (size, attachment, installation side).
►
Adjusting the tray to the user's body size should be performed in the presence of the user.
Mounting the adapter for the swivel mechanism
1) Remove the side panel.
2)
Only when necessary:
Loosen the set screws on the bottom of the arm support and with a forward motion pull
out the control panel holder (not illustrated).
3) Insert the adapter for the swivel mechanism (see fig. 1, item 1) into the mounting rail below the gap (see fig. 1,
item 2).
4) Secure the adapter in the mounting rail using the set screws (see fig. 1, item 3).
5) Replace and fasten the side panel.
Positioning and attaching the tray
1) Insert the swivel mechanism into the retainer and secure it slightly with the clamping lever (see fig. 2, top left).
2) Put on and align the tray top. In doing so, check to ensure the tray retainer is centred.
3) Line up the 3 holes in the tray top with the 3 holes in the tray retainer (see fig. 2, top right).
4) Secure the tray retainer in this position with 2 screws (see fig. 2, bottom left).
5) Attach the tray top to the tray retainer with 3 screws (see fig. 2, bottom right). Carefully tighten the screws.
Mounting the supports
1) Slide the 1st support onto the clamping profile (see fig. 3, left).
2) Set the 2nd support onto the tube of the swivel mechanism (see fig. 3, right).
3) Provisionally set the depth of the tray top. Clamp the swivel mechanism into place.
4) Position the supports so they can be mounted at the front and with a safety distance on the outside.
5) Mount the supports on the tray. To do so, drill 2 holes in the tray top with a diameter of
Ø 6 mm
, respectively at
the appropriate positions.
6) Countersink the holes with a spherical countersink.
7) Attach each support with 2 of the supplied countersunk head screws. If necessary, compensate for the space
between the supports and tray top with washers.
Adjusting the depth
1) Open the clamping lever on the swivel mechanism and pull the tray forward slightly (see fig. 4, left).
2) Pull the pin and swing the tray away to the side (see fig. 4, right).
3) Sit the user into the seat.
4) Fold the tray down and lock it with the pin.
5) Adjust the depth.
CAUTION! The user must not get pinched by the tray. Ensure that the user's arms can rest on the tray
and that the front round cutout does not press on the user's body.
6) Firmly engage the clamping lever on the swivel mechanism.
12
Preparing the product for use
493U75=SK300, 493U75=SK330
