WiJET.Video Technical Manual
Page 25 of 29
Appendix B: REGULATORY COMPLIANCE
The Referenced equipment:
is herewith confirmed to comply with the requirements of FCC Part 15 rules. The
operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that
may cause undesired operation.
FCC ID: MKZWIJETVIDEO
FCC Rules and Regulations - Part 15
Warning:
This device has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the Federal Communications
Commissions Rules and Regulations. These limits are designed to provide
reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
.
Relocate your WLAN equipped laptop computer.
.
Increase the separation between the WLAN equipped laptop computer and
other electronics.
.
Connect the WLAN equipped laptop computer into an outlet on a circuit
different from that of other electronics.
.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance of 20cm between the radiator & your body.
Caution:
Changes or modifications not expressly approved by seller could void the
user’s authority to operate the equipment.
Warning:
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
