English-5
BEFORE BREWING YOUR FIRST ESPRESSO
1. Make sure the unit is switched off, the control knob is in the off “ ” position and it
is unplugged from the electrical outlet.
2. First remove and then wash the water reservoir, lid, filter holder and filters in a
mixture of mild detergent and water. Rinse each thoroughly and place them back
into the unit. Refer to the instructions below on “How to Brew Espresso” before
removing the filter and filter holder.
3. To clean the inside of the appliance, follow steps listed on “How to Brew
Espresso” using water only. Do not immerse the appliance in water or attempt to
reach any of its internal parts.
IMPORTANT
To prime the pump before the initial brew, run brewing cycle for 30 seconds following
the steps below:
1. Add water to the water reservoir.
2. Turn the On/Off Switch on “ ”.
3. Press the Brew/Steam Switch to the brew “ ” position and wait for Brew/Steam
Indicator Light to become solid green.
4. Place a cup underneath the brew head and turn the control knob to the brew
“ ” position.
5. After 30 seconds turn the control knob to the off “ ” position. (Some water and/
or steam may release during process).
HOW TO BREW ESPRESSO
PREPARATION:
Gather the following prior to brewing
• Fine espresso ground coffee or OriginalLine Nespresso
®
* capsule
• Tap Water (or, preferably your favorite bottled water)
• Teaspoon
• Your favorite demitasses
1. Make sure the unit is switched off and the control knob is in the off “ ” position.
2. Fill the reservoir with water. You may either use bottled water or a jar to fill it up
or remove it from the unit and then fill it up under the tap. If you have removed it
from the unit to fill up with water, please make sure to place it back tightly in its
place. Fill the reservoir with the desired amount of water ensuring it ranges within
the “Min” and “Max” markings on the tank. Never use warm or hot water to fill the
water reservoir.
3. Close the water reservoir lid.
