Ossur PROPRIO FOOT, Техническое руководство

Страница: 13 / 24

13 12
CALIBRATION
Calibration must be performed during the initial fitting to calibrate the proprio foot ® to the user’s individual
gait. During calibration, proprio foot
®
recognizes the user’s specific gait parameters, allowing for accurate and
consistent terrain detection. For calibration the user must walk on level ground for at least 15 consecutive strides
without interruption.
• Have the user stand still.
• Make sure the keypad is active.
»
The LED blinks green and yellow (The keypad will lock
automatically after 60 sec. of use).
• Make sure the user has access to a path on level ground long
enough to complete at least 15 strides without interruption.
• To enable Calibration, hold down and press nine times.
»
The system confirms with a beep and a vibration.
»
The LED blinks green and yellow.
• Have the user walk on level ground at a self-selected walking
speed until completion of calibration is confirmed by a beep
and vibration.
»
The LED blinks green.
»
The system is now properly calibrated to the user and enabled for
normal adaptive functions.
note: Make sure the surface is completely flat. It is
recommended that calibration is performed on an indoor surface. No sharp turns should be taken during
calibration.
note: The user may take gentle turns during the calibration walk. If the calibration is not completed after
approximately 15 strides, see below.
TROUBLESHOOTING
• Ensure the correct alignment.
• Ensure there are no extreme gait deviations, such as significant circumduction or rotation, as this may
prevent the completion of calibration.
• Ensure consistent walking speed.
• Avoid walking in a circle or sharp curves.
• If calibration is not confirmed after 15 strides, you must perform calibration again.
• If the alignment is changed you must perform the calibration again.
• If for any reason the LED turns red the procedure must be repeated.
To cancel the calibration, hold down and press nine times.
hold
9×
Press
1×
1×