OSS ExpressBox 2200, Руководство пользователя

Страница: 17 / 79

One Stop Systems
ExpressBox 2200 | 2 Hardware Installation 17
2.5 Install Host Interface card
Begin the installation of your Host interface card by first powering down your computer.
The Host interface card is a “half-height,” x8-capable PCIe card mounted to a “full-height” bracket as shown below.
For low profile case applications, you may need to change the mounting bracket to the low profile bracket that shipped with your system. This
is done by removing the screws that hold the card to the bracket. Make sure you are using proper ESD procedures when completing this action.
WARNING
YOU MUST ONLY INSTALL THE PCIe HOST CARD INTO A PCI EXPRESS SLOT .
Only use an Interface card WITH bracket. This will ensure that your PCIe host card can only be inserted into a PCIe slot.
Although PCI Express cards without brackets may fit into conventional PCI slots, you run the risk of damaging the PCI
Express host card if you insert it into a PCI slot.
Once the host computer is off and all power cords are disconnected from the AC outlet, remove the cover.

Check the red Dipswitch (SW1) on the Host interface card, make sure it is set to OFF= HOST.

Check the SW2 Dipswitch, both toggle switches are set to OFF position (x8).
If the host card is set to expansion mode (ON=EXP), it may not work properly.