Installation and operating instructions: Blind Control Unit DALI BC ADVANCED RI
Page 5
Installation
Connect the louvre blind actuator as shown in Fig. C.
Fig.
C
AB
N
N
L
PE
AUF
M
BK
BN
BU
PK
Antenne
L
N
1 sec
RD
GN
-
Prog.
4 sec
-
Notes
•
The distance from equipment that operates with high frequencies (such as microwave ovens, hi-fi
systems and TVs) must be at least 0.5 m.
•
To avoid overloading the receiver (actuator), the distance between the louvre blind actuator and a
transmitter must be at least 1 m.
When you have installed the unit, please give these operating instructions to the customer.
3.
Programming a radio transmitter
When a transmitter is being programmed, the sensitivity of the receiver is reduced to approx. 5 m. The
distance between the louvre blind actuator and the transmitter to be programmed should therefore be
0.5 m to 5 m.
Procedure
1. Hold down the programming button for about 4 seconds to switch to the programming mode.
The LED will flash red for about 1 minute (Fig. D). During this time a radio channel can be
programmed.
Fig.
D
Prog
1 min
t
2. Issue a radio telegram from the selected transmitter (e.g. the hand-held transmitter) by holding
down a channel or lighting scene button until the LED lights up permanently to indicate that
the louvre blind actuator has acknowledged storage (Fig. E).
