Page 4
Installation and operating instructions: Blind Control Unit DALI BC ADVANCED RI
2.
Installation
Important: Electrical equipment may only be installed by qualified electricians.
Since the unit has only basic insulation, radio transmitters may be programmed or deleted only
by qualified electricians. This only applies if components of the electrical system have to be
opened for the purpose.
Because the load lines of the unit briefly carry current when mains voltage is applied, any
unused lines must be insulated.
Install the louvre blind actuator (Fig. B
c
) in a flush-type box behind a blanking cover (Fig. B
e
).
For application outside the flush-type box, make sure the unit is adequately protected against
accidental contact (for example, install it in a distribution box). The legend must be pointing forwards
when the unit is installed.
Fig.
B
N
AC 230 V~
L
c d
e
The louvre blind actuator was developed exclusively for switching louvre blind or shutter motors.
Other
applications may be dangerous (e.g. controlling a roller gate).
Only use louvre blinds or shutters with mechanical or electronic end position switches.
Electronic interlocking of the unit means there is a minimum direction changeover time of about 1
second.
Check the information provided by the motor manufacturer regarding changeover time and
maximum operating time.
Antenna
To achieve optimum radio reception, lay the antenna out straight (Fig. B
d
), not wound up.
As the antenna has only basic insulation it must not be led out of the flush-type or surface mounted
box.
Keep the antenna the minimum prescribed distance away from large metal parts, such as metal door
frames.
Do not shorten or lengthen the antenna, or strip off the insulation.
