9
RECOMMENDATION
-
The product is intended for use in a low-pressure closed system. The safety valve is activated at a
water pressure of 3 bar.
-
For installation in a rooms which does not conform to the wetroom standard, a watertight drip
tray with overflow pipe > 18 mm. inside diameter should be fitted under the product, in addi-
tion to an automatic stop cock with sensor. This will prevent possible material damage.
3.5.4 Fitting instructions
3.5.5 Fitting recommendation
!
CAUTION
!
The product should be placed in a room with a drain, in accordance with the wetroom standard / latest TEK. Over-
flow from safety valve to drain should be fitted anyway, see section 1.3. When the product is fitted in a bench, an
automatic water stop valve with sensor should be installed to prevent any water damage. Product liability will only
apply if this is followed.
!
The product should be properly aligned vertically and horizontally, on a floor suitable for the total weight of
the product when in operation. See type plate.
!
The product must have a clearance for servicing of 40 cm in front of the front.
3.6 Maintenance
MAINTENANCE INSTRUCTIONS
!
Maintenance should be carried out by persons over 18 years of age, with sufficient under-
standing.
!
Annual inspection of safety valve:
-
Open valve for 1 min. by turning the knob (8) approx. 90 degrees to the open position.
-
Visually check that the water is flowing freely to the drain.
-
YES = OK. Close the valve by turning the knob (8) a further 90 degrees to the closed position.
-
NO = NOT OK. Disconnect power supply / shut off water supply. Contact installer.
8
