OSO HOTWATER 800 0952, Руководство по установке

Страница: 61 / 160

13
! WARNING
Constant voltage present in the junction box. Be-
fore any electrical work is done, the power supply
must be disconnected and secured against acti-
vation while the work is in progress.
Turns Temperature
0 Approx. 70°C
1/4 Approx. 60°C
1/2 Approx. 50°C
3/4 Approx. 40°C
1
5.2 Maintenance
5.1 Settings
5.1.1 Thermostat setting
The thermostat on the product is adjustable from
50-75°C. The thermostat should not be set lower
than 65°C to prevent bacteria growth. To adjust
the temperature:
A) Disconnect the power supply.
B) Remove the cover (4) low down on the front of
the tank with a screwdriver.
C) Adjust the temperature on the thermostat (7)
with a screwdriver.
Fit the cover (4) before connecting the power
supply. Changing the temperature setting on the
thermostat only changes the temperature of the
water in the tank. Temperature to the taps is ad-
justed on the mixer valve.
5.1.2 Resetting the safety thermostat
The safety thermostat on the product cuts out
when there is a risk of overheating. This is reset
by removing the cover (4) and pressing the red
‘RESET’ button (6). If the thermostat cuts out re-
peatedly, contact the installer.
5.1.3 Adjusting the feet
The product is equipped with three factory-fit-
ted feet, adjustable from 0-40 mm. Screw the
feet out a minimum of 15 mm from the bottom
of the product. Adjust the feet individually un-
til the product is standing firmly vertically and
horizontally.
5.1.4 Setting the mixer valve
The outgoing hot water temperature from the
product to the taps in the home can be adjusted
with the knob on the mixer valve. To adjust the
temperature:
A) Turn the adjustable knob (1) all the way to ‘+’
B) Then turn the knob towards ‘-’ to the desired
temperature.
5. USER GUIDE
MAINTENANCE INSTRUCTIONS
!
Maintenance should be carried out by persons over 18 years of age, with suf-
ficient understanding.
!
Annual inspection of safety valve:
- Open valve for 1 min. by turning the knob (3) approx. 90 degrees to the open
position.
- Visually check that the water is flowing freely to the drain.
- YES = OK. Close the valve by turning the knob (3) a further 90 degrees to the
closed position.
- NO = NOT OK. Disconnect power supply / shut off water supply. Contact in-
staller.
RESET
RES
ET
M2
1
2
3
4
THERM-O-DISC
60°C 90°C
80°C 70°C
1
2
RESET
RES
ET
M2
1
2
3
4
THERM-O-DISC
60°C 90°C
80°C 70°C
1
2
7
6
3