OSO HOTWATER 800 0952, Руководство по установке

Страница: 60 / 160

12
4.1 Filling with water
First check that all pipes are connected correctly.
Then proceed as follows:
A) Open a hot tap – leave it open
B) Turn the adjustable knob on the mixer valve all
the way to ‘+’.
C) Open the cold water supply to the product.
Check that the water from the open hot water tap is
flowing freely, without any air locks. Close hot tap.
Filling/emptying coil: Follow the instructions for an
external heat source.
4.2 Turning on the power
When the cylinder has been filled with water, the
power can be switched on.
A) Insert plug into specified wall socket or turn on
on switch/fuse.
4.3 Setting the mixer valve
The outgoing hot water temperature from the
product to the taps in the home can be adjusted
with the knob on the mixer valve. Adjusting the
mixer valve does not affect the temperature of the
hot water in the product.
To adjust the temperature:
A) Turn the adjustable knob (1) all the way to ‘+’
B) Then turn the knob towards ‘-’ to the desired
temperature.
4.6 Handover to end-user
4. INITIAL COMMISSIONING
THE INSTALLER MUST:
Brief the end-user on safety and maintenance
instructions.
Brief the end-user on settings and emptying the
product.
Hand this installation manual over to the end-
user.
Enter contact details on the type plate on the
product.
4.4 Control points
A) Check that all pipe connections to/from the
product are tight and not leaking.
B) Check that the power supply to the product is
not at risk of exposure to mechanical, thermal
or chemical damage.
C) Check that any overflow pipe from the safety
valve is clear, undamaged and frost-free with
a fall to the drain.
D) Check that the product is standing firmly
vertically and horizontally.
! WARNING
The water temperature in the product is 70°C and
could cause scalding. Before emptying, a hot tap
should be opened to the max. pressure/temper-
ature for min. 3 minutes.
After emptying, close the drain valve. Close all
open taps. Adjust the mixer valve to its origi-
nal setting. Fit the cover (2) ahead of the drain
valve.
Turns Temperature
0 Approx. 70°C
1/4 Approx. 60°C
1/2 Approx. 50°C
3/4 Approx. 40°C
1
2
3
5
4
A) Disconnect the power supply.
B) Shut off incoming cold water supply.
C) Open a hot tap to the maximum
– leave open (prevents vacuum).
D) Open the mixer valve all the way to ‘+’.
E) Remove the cover over the drain valve (2) by
loosening the screw (5).
F) Open the drain valve (3). The product
empties.
4.5 Emptying of water