SYSTEM SET-UP
1. Place pump on horizontal surface or hang by means of the hook.
2. Open mattress on the bed, secure it with the end flaps or straps (see 2). Air tubes
must be at foot end of bed.
3. Connect air feed tubes to air outlet on the mattress (see 3a) and pump (see 3b),
ensuring that the tubes are not kinked or twisted. Allow space for bed rails to drop
freely.
4. Turn on the power. After a beep sound, the pump will begin the operation.
5. The pump will enter static mode initially when the power is turned on. The cycle
time is set at 1st LED, 10 mins and the pressure level is set at 3rd LED (see 5). First
will inflate the mattress to 18±2 mmHg and then enter alternate mode.
6. For switching to static mode, press the Alternate/Static switching button and its
indicator will come on (see 6). Press the button again to switch back to alternate
mode.
Series 3-V4
RMS200 REPLACEMENT SYSTEM
© OSKA 2016
4
5
1
1
4
2
2
6
3
3
5
7
4
5
6
SYSTEM SET-UP
Place pump on horizontal surface or hang
by means of the hook.
Open mattress on the bed, secure it with
the end flaps or straps (see 2). Air tubes
must be at foot end of bed.
Connect air feed tubes to air outlet on
the mattress (see 3a) and pump (see 3b),
ensuring that the tubes are not kinked or
twisted. Allow space for bed rails to drop
freely.
Turn on the power. After a beep sound,
the pump will begin the operation.
The pump will enter static mode
initially when the power is turned on.
The cycle time is set at 1st LED,
10 mins and the pressure level is set
at 3rd LED (see 5). First will inflate
the mattress to 18
±
2 mmHg and
then enter alternate mode.
For switching to static mode, press
the Alternate/Static switching button
and its indicator will come on (see
6). Press the button again to switch
back to alternate mode.
OPERATION
During normal operation, the pump will
monitor pressure changes. If the pressure
is below a user-defined pressure level, the
pump will automatically start to inflate the
mattress. The pump will stop when the
user-defined pressure level is reached.
If the pressure is consistently low, the
audible alarm will beep and its indicator
will come on to bring attention to a low
pressure condition.
If there should be obvious leakage, for
example caused by loose connection of
tubes, the audible/visible alarm will be
activated.
5
6
3B
3B
3A
2
Bi-elastic, vapour
permeable top cover
Series 3-V4
digital pump
Carry
Handles
Air outlet connection
Air feed tubes
CPR valve
Anchor
end straps
Press the Alarm Reset button to mute
alarm: its indicator will flash
Press the Alarm Reset button again to have
the audible alarm and its indicator on.
For nursing and caring convenience, press
the Auto Firm button to automatically
inflate the mattresses to the maximum level
(above 180kg) for about 30 minutes. The
pressure will return to a previously user
defined level after 30 minutes.
In the case of a poor connection with
tubing, or any other air leakage from the
mattress, low pressure conditions will
occur and the audible/ visual alarm will be
activated.
7
