Oshkosh JLG 1500SJ, Руководство по обслуживанию и ремонту

Страница: 408 / 706

SECTION 5 - BASIC HYDRAULIC INFORMATION & HYDRAULIC SCHEMATICS
5-54 – JLG Lift – 3121262
2. Use a soft mallet to tap a new wiper seal into the cylin-
der head gland groove. Install a new wear ring into the
cylinder head gland groove.
3. Place a new “O-ring and backup ring in the outside
diameter groove of the cylinder head.
4. Install washer ring onto rod, carefully install the head
gland on the rod, ensuring that the wiper and rod seals
are not damaged or dislodged. Push the head along the
rod to the rod end.
5. Place a new O-ring and backup rings in the inner piston
diameter groove.
6. Using suitable protection, clamp the cylinder rod in a
vise or similar holding fixture as close to the piston
threads as possible.
7. Carefully thread the piston on the cylinder rod hand
tight, ensuring that the o-ring and back-up rings are not
damaged or dislodged.
NOTE: When installing the tapered bushing, piston and mating
end of rod must be free of oil.
8. Assemble the tapered bushing loosely into the piston
and insert capscrews through the drilled holes in the
bushing and into the tapped holes in the piston.
9. Tighten the capscrews evenly and progressively in rota-
tion to 9 ft.lbs. (12 Nm).
10. After the screws have been torqued, tap the tapered
bushing with a hammer (16 to 24 oz.) and brass shaft
(approximately 3/4" in diameter) as follows;
a. Place the shaft against the cylinder rod and in con-
tact with the bushing in the spaces between the
capscrews.
b. Tap each space once; this means the tapered bush-
ing is tapped 3 times as there are 3 spaces between
the capscrews.
11. Retorque the capscrews evenly and progressively in
rotation to 9 ft.lbs. (12 Nm).
Figure 5-23. Wiper Seal Installation
Figure 5-24. Installation of Head Seal Kit
Figure 5-25. Tapered Bushing Installation
Figure 5-26. Seating the Tapered Bearing