Oshkosh JLG 1043, Инструкция по эксплуатации и безопасности

Страница: 70 / 254

Section 3- Controls and Indicators
3 - 20 31211368
Load Stability Indicator - LSI (if equipped)
The LSI ( 1 ) provides visual and audible indication of forward stability limitations when
machine is static on firm, level surface.
• When approaching forward stability limitations LEDs progressively illuminate, green
( 2 ), then orange ( 3 ) and finally red ( 4 ).
• If the red LED illuminates the warning buzzer also sounds.
The LSI has two modes:
Active Mode
• As the telehandler reaches forward stability limitations and the red LED (
4
)
illuminates, the automatic function cut - out is activated. All boom, frame level and
outrigger functions (if equipped) are disabled except for boom retract and boom
lift. Retract boom to re
- enable functions.
Note: When functions are cut-out, the LSI Override Switch can be used to temporarily
re-enable them. See “Left Dash Control Panel” on page 3 - 10.
WARNING
TIP OVER HAZARD. The LSI considers only longitudinal stability limitations, observe
all operating parameters. Failure to follow operating parameters of the telehandler
could damage the equipment and/or cause tip over.
OF0070
1
STOP STOP
1001181531A 1001181531A
3
4
2
X
5
https://www.forkliftpdfmanuals.com/