Operating manual external touch control panel (Smart) Page: 3 of 14
Installation site
The external control panel includes, among other things, buttons for operating the swimming pool
cover. For this reason, the external control panel may only be installed in a location that allows an
unrestricted view of the entire swimming pool. The external control panel must not be installed in
positions from which the swimming pool cannot be fully viewed! It is not suitable for installation
outside of buildings.
Mounting
The control panel is designed for flush mounting using the tile frame supplied. Before
opening the housing, the device must be de-energized.
The tile frame is installed by the tiler while the tiles are being laid.
1.)
Prepare the tile frame:
Bend all four fastening tabs backwards and then outwards.
Tile frame
Bend the fastening
tabs backwards
Bend the fastening tabs outwards
2.)
Make a recess at the intended mounting location in the wall, which will later
accommodate the tile frame and the housing.
3.)
Align the tile frame in front of the wall recess as follows:
horizontally
perpendicular
the front edge of the tile frame must be flush with the tiles!
4.)
Fix the fastening tabs to the wall with screws or nails and fix them with mortar or tile
adhesive.
5.)
Lay tiles right up to the outer edge of the tile frame.
Installation of the control panel in the tile frame
The installation of the control panel in the tile frame is done by an electrician after the wall
has been covered with tiles and grouted.
1.)
Lead connecting cable through the cable gland, and then tighten the pressure screw
of the screw. The cable entry must be watertight.
2.)
Insert the metal housing into the tile frame and fasten it with the enclosed 4mm
stainless steel screws. A screw is screwed into each of the 4 corners.
3.)
Connect the cable to the control panel in accordance with the installation and
operating instructions. The clamps are on the back of the board.
