background image

Operating Instructions PC-25 page 5 (10)

Since an exact temperature control is only carried out with a good heat transmission
within the temperature sensor and the pool water, an 

-immersion shell R ½"

(art.no. 3200200003) has to be installed into the pipe system.
Any polarity of the sensor is possible.
Additionally it is possible to connect a solar temperature sensor (art.no.3100000030)
to the clamps 32 and 33. As a standard the temperature sensor is delivered with a
cable length of 20m. If required it can be lengthened with a two-core cable (minimum
diameter 0,5mm²) up to a maximum of 50m. It should be avoided to lay the sensor
lead near power lines to exclude possible disturbance. The solar temperature sensor
is to be installed at the output of the solar collector and it must have a good thermal
contact to the backflowing water.

Control elements on the front plate:

Set temperature

Set circuit time
Pilot light filter pump

Select operating mode

Pilot light operating mode

Set time

Interrogate soalr temperature

Pilot light solar operation

Pilot light heating
Heating ON/OFF

LCD-display

Adjustment buttons

LCD-display

23,4

14:46

°C

Normal operation display with current water temperature and time.

level-

control

The filter pump has been switched on by the level control NR-12-TRS-2 .

back-

washing

The filter pump has been switched on by the backwash control
EUROTRONIK .

pump

locked

The filter pump has been switched off by the EUROTRONIK, the level
control NR-12-TRS-2 or by the winding protective contact.

motor-

protect.

The filter pump has been switched off by the electronic motor protection.
The pump can be switched on again with the key   after it has been cooled
and after the cause for the overload has been settled.

phase

fault

The filter pump has been switched off, because there is no current in all
three phases of the three-phase-current network. After the mistake has
been removed, the pump can be switched on again with the key   .

sensor

defect.

The temperature control is out of operation, because the temperature
sensor is not connected or defect.

Содержание 3100000430











Отзывы: