Oryx solutions SCA 1200ht, Руководство пользователя, Страница: 14 / 26

14
Cleaning the parts
To activate the cleaning cycle after setting the time and temperature, and adjusting the
liquid level, press the button. Illuminated bars will sweep under the temperature
display when the pump is operating.
Parts can take a few hours or longer to clean. Cleaning time is affected by the size of the
part, the amount of support material, part geometry, and the pH level of the cleaning
solution.
Parts can be checked at any time during a cleaning cycle by opening the lid, carefully
lifting the Large Parts Basket from the tank, turning the basket 90° and resting it on the
rear support bracket and then pulling it forward on to the front tank ledge.
Protective gloves and eyewear should always be worn when lifting the basket from the
tank.
If the parts are clean before the end of the cleaning cycle, halt the cycle by pressing the
button.
Des gants de protection et des lunettes protectrices devraient être portés en tout temps
lorsque vous soulevez le panier du réservoir.
Si les pièces sont propres avant la fin du cycle de nettoyage, cessez le cycle en appuyant
sur le bouton .
Figure 7 Basket Lift Position
Pull Basket Forward