Orthman 1tRIPr, Руководство оператора

Страница: 23 / 53

FIELD SETTINGS
FIELD SETTINGS
AVOID CRUSHING.
Make sure all personnel are clear of implement at all times
implement is in motion. Be aware of obstructions above, below, and around implement
when in operation or transport. Injury or death can result from being struck by the imple-
ment.
NT TOOLBAR FOLDING PROCESS
The 1tRIPr
®
XDNT machine uniquely folds into a more compact configuration for easier transport. During the folding process, two different folding actions will
occur. First, from the unfolded state, the outer wings will revolve inward towards the tractor, until they become seated and “locked” in the outer wing latch (
A,
B,
and
C
). Next, the mid wings will begin to fold vertically until they make contact with the wing rests on the toolbar center section (
D
and
E
). The machine is
now folded and ready for transport.
WARNING
DANGER
A B
C
D E
6 - 5
TOOLBAR HEIGHT AND
ORIENTATION
PLACE TRACTOR IN PARK AND REMOVE KEY BEFORE
DISMOUNTING TRACTOR TO ADJUST IMPLEMENT.
NEVER ALLOW RIDERS ON TRACTOR OR IMPLEMENT.
Riders hinder operator visibility
and can be thrown from the implement and/or be struck by foreign objects resulting in injury or death.
NOTE: WHEN SETTING TOOLBAR HEIGHT AND ORIENTATION, DISREGARD ROW UNIT PERFORMANCE.
TOOLBAR HEIGHT AND ORIENTATION MUST BE ESTABLISHED PRIOR TO TOOLING ADJUSTMENT. FOR
1TRIPR
®
TOOLING ADJUSTMENT, REFER TO THE 1TRIPR
®
ROW UNIT OPERATOR’S MANUAL.
The top and bottom of the toolbar must operate parallel with the ground surface. Adjustment of tractor
hitch tab height, tongue lift cylinder stops, and/or lifting gauge wheel cylinder stops, will allow the toolbar
to operate parallel with the ground surface.
Have an assistant pull the tractor and implement slowly forward in the field position as you view the end of
the toolbars from a safe distance. Observe the toolbars heights and orientations while in operation. Make
adjustments accordingly until the top and bottom of both toolbars operate parallel with the ground surface .
1tRIPr
®
XD in raised position
In the rasied position, there should be adequate clearance between the ground surface and the 1tRIPr
®
shank.
1tRIPr
®
XD in field position
1. In the field position, the 1tRIPr
®
XD toolbar should run 30”-32” (76-81 cm) above the ground surface.
2. Row unit parallel linkage should run parallel with the ground surface and not be resting on the toolbar.
off
W A R N I N G
W A R N I N G
30-32”
(76-81cm)
Ground Surface
Hitch
Tab
height
6 - 4