FIELD SETTINGS
SMART IMPLEMENT GUIDANCE
6 - 1
PLACE MACHINE TOOLBAR COMPONENTS IN “FIELD READY” POSITION:
AVOID CRUSHING.
Do not stand between tractor and implement when connecting or disconnect-
ing implement. Injury or death can result from being trapped between the tractor and implement.
AVOID CRUSHING.
Be sure the weight of the machine in fully supported by the tractor and carrier
lift hydraulic cylinders before removing bar stands from the storage position.
PLACE TRACTOR IN PARK AND REMOVE KEY BEFORE
DISMOUNTING TRACTOR TO ADJUST IMPLEMENT.
NEVER ALLOW RIDERS ON TRACTOR OR IMPLEMENT.
Riders hinder operator visibil-
ity and can be thrown from the implement and/or be struck by foreign objects resulting in injury or death.
Raise bar stand up
1. Make sure machine is attached securely to tractor
drawbar.
2. Make sure cab hydraulic control configuration is
easily accessible and to the preference of the primary
operator.
3. Make sure tractor is adequately ballasted for
safe operation. Refer to owner’s manual for proper
ballasting instructions.
4. After tractor is properly hooked up, raise the
machine and remove Bar stand pin and raise bar stand
to raised position, and replace bar stand pin.
5. Move wing lock pin from wing lock position to Lock
pin storage position. The toolbar will not fold with the
wing lock pins installed in the lock position.
NOTE:
FOR NARROW TRANSPORT TOOLBAR MACHINE
BAR STAND PLACEMENT, REFER TO PG. 6 - 3
FIELD OPERATION
W A R N I N G
off
W A R N I N G
Bar stand pin
DANGER
DANGER
Lock pin storage position
Rigid wing lock position
Rigid wing lock pin
PREPARATION AND SET UP
(CONTINUED)
CALIBRATION (CONT.)
4. Position the implement feedback sensor.
A. Once the previous calibration steps have been performed correctly (i.e. all steering components are
centered), the voltage read-out found on your steering system’s monitor should read close to 2.5 volts. If this is
not the case, the implement feedback sensor will need to be adjusted until the read-out on the steering system’s
monitor reads as close as possible to 2.5 volts.
B. Adjust the implement feedback sensor by adjusting the sensor connecting linkage in the same manner as an
adjustable strut would be adjusted.
C. For additional information on the implement feedback sensor, refer to your guidance system’s operator’s
manual.
HYDRAULICS
HOSE ROUTING
CONNECTS TO TRACTOR
SCV “PRESSURE” PORT
CONNECTS TO TRACTOR
SCV “RETRACT” PORT
STEERING HYDRAULIC
CYLINDER
HOSES SHOULD ROUTE INSIDE TOOLBAR STRINGERS
HOSES SHOULD ROUTE ALONG TONGUE
5 - 6
