OROTIG Revo S L0F102HN, Руководство оператора, Страница: 27 / 28

Operator's manual
Ch
ap
ter
:
Di
ag
no
st
ic
s
27
ERROR: Cod. 11 Vcap low 1
Problem: The voltage on the first bank of capacitors has not reached the required value or is not charged.
Solution:

Check the electrical system.

Ensure the correct operating voltage.

Contact technical support.
ERROR: Cod. 12 Vcap High 1
Problem: The voltage on the first bank of capacitors has reached its limit.
Solution:  Check the electrical system.
 Ensure the correct operating voltage.
 Contact technical support.
WARNING: Cod. 13 IMS hot 1
Problem: The temperature of the first IMS circuit for the flash guide lamp is too high.
Solution:

Wait for the device to automatically return to normal, do not turn off the device.

Check that the vents are open and not blocked.

Check the condition of side filters and clean or replace if necessary.

If automatic recovery does not happen, contact technical support.
ERROR: Cod. 14 Precharge 2
Problem: The second circuit of the pre-charging of the capacitors does not activate.
Solution:  Check the electrical system.
 Make sure there are no problems with the electricity.
 Ensure the correct operating voltage.
 Contact technical support.
WARNING: Cod. 15 IMS hot 2
Problem: The temperature of the second IMS circuit for the flash guide lamp is too high.
Solution:

Wait for the device to automatically return to normal, do not turn off the device.

Check that the vents are open and not blocked.

Check the condition of side filters and clean or replace if necessary.

If automatic recovery does not happen, contact technical support.
ERROR: Cod. 16 Vcap High 2
Problem: The voltage on the second bank of capacitors has reached its limit.
Solution:  Check the electrical system.
 Ensure the correct operating voltage.
 Contact technical support.
ERROR: Cod. 17 Vcap low 2
Problem: The voltage on the second bank of capacitors has not reached the required value or is not charged.
Solution:

Check the electrical system.

Ensure the correct operating voltage.

Contact technical support.
WARNING: Cod. 18 CCPS Hot 2
Problem: The temperature of the electronic circuits for the second lamp is too high.
Solution:  Wait for the device to automatically return to normal; do not turn it off, leave it on to speed up the cooling
process.
 Check that the vents are open and not blocked.
 Check the condition of side filters and clean or replace if necessary.
 If automatic recovery does not happen, contact technical support.
ERROR: Cod. 19 Simmer 2
Problem: The firing circuit of the second lamp is not working or the lamp does not light.
Solution: Contact technical support.
ERROR: Cod. 20 COM fail
Problem: There is no communication between the internal circuit boards.
Solution: Contact technical support.
ERROR: Cod. 21 Syncronizing
Problem: There is a problem with the synchronization signal between the circuit boards.
Solution:

Wait for the device to automatically return to normal, do not turn off the device.

If automatic recovery does not happen, contact technical support.