8
The First Step before Programming- Make A Master Card
●
The system needs a Master Card to set it into programming mode.
Before programming, it is
iiII
necessary to make a Master Card by the owner.
●
In case the Master Card is lost, it is necessary to make a new Master Card to replace it. Once a
iiII
new Master Card is made, the old one is invalid.
Procedures of Creating A New Master Card with CMC Jumper:
1) Switch OFF power to the reader completely
2) Put the CMC Jumper from OFF to ON position (The jumper is on the circuit board)
3) Switch ON power again.
iiiii
Response
:
The reader gives continuous beeps. The Status LED (blue) starts to flash for one
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
minute. This is the allowed time for making a Master Card.
4) Put the jumper back to OFF position.
iiiii
Response
:
The beep stops.
5) Read an EM card (a new EM card or keyfob).
iiiii
Response
:
Two beeps confirm reading successful.
6) Press the Bell button 1 Time to save the Master card and exit CMC mode.
i
iiiii
Response
:
Two beeps confirm reader back to normal operation. The Status LED is ON.
7)
Label the card as MASTER.
iiiii
It is a card for programming authorization purpose. Do not mix it with other User Cards and keep
iiiii
it in a safe place.
CREATE A MASTER CARD (CMC)
NOTE:
The system will
get stuck and the status LED will turn OFF
if the Master Card can not
be made within the allowed time of one minute. It is necessary to repeat procedures 1-6
and try again.
CMC JUMPER
CMC
2. OFF
1. ON
1) Read User Card to Open Door
● Read User Card
once
.
● Two beeps confirm success of reading a valid user card and its group LED turns ON during the
iiii
door lock strike.
● Five beeps are generated for invalid card.
2) Read Super User Card to Open Door
● Read Super User Card
twice within 3 seconds
.
● Two beeps confirm success of reading a valid super user card and its group LED turns ON during
iiii
the door lock strike.
● Five beeps are generated for invalid card.
iiii
Note
:
iiii
Super User Card is valid all the time in both Normal & System Lock-up conditions.
3) Read Super User Card to Make System Lock-up
● Read Super User Card
once
, and then, press
BELL button once within 3 seconds
.
● Two beeps confirm success. The Status LED (blue) flashes slowly (0.5sec ON, 1sec Off) during
iiii
the system lock-up in effect.
● Five beeps are generated for invalid card.
iiii
Note
:
● During the lock-up time, the Status LED (blue) flashes slowly and the reader refuses all the
iiii
general user cards except the Super User cards.
● The Egress Button works normally all the time and is not affected by the lock-up function.
● The Door Bell button works normally all the time and is not affected by the lock-up function.
4) Read Super User Card to Release System Lock-up
●
i
Read Super User Card
once
, and then, press the
BELL button once within 3 seconds
.
●
Two beeps confirm success. System goes back to normal operation and the Status LED (blue)
iiiii
turns ON from flashing.
●
ii
Five beeps are generated for invalid card.
OPERATION
17
